CONSTRUCTION
-Triple element piston pump directly driven
• by an oil immersed AC motor.
-Steel resevoir and cast foot housing

PRESSURE
Up to 10,000 psi (700 bar)

FLOW RATE
Up to 0.82 gpm (3.1 l/min)

MOUNTING TYPE
4 threaded mounting holes through the cast foot housing

WEIGHT
(dry units without control valves)

MOUNTING POSITION
Unit must be mounted vertically

SEALS
BUNA N

OIL TEMPERATURE
-4° F to 176° F (-20° C to 80° C)

FILTRATION
Maximum permissible contamination:
ISO 19/16

MOTOR VOLTAGE
3-Phase:
230/460V - 60 hz

Single Phase:
115/220V - 60 hz

Amp Draw:
(see motor pump options)

Connection Type:
Terminal strip in terminal box

Terminal Box:
DIN 40050-IP54

Motor Rotation:
Clockwise or counterclockwise

THERMAL SWITCH
Actuating Temperature:
175° F (80° C)

Switchback Hysterisis:
20 to 50° F

Maximum Voltages:
250V AC / 60V DC

Contact:
Normally Closed

Connection:
In terminal box

S2 - SHORT TERM OPERATION
The unit operates for a short period of time, reaching its maximum thermal limit. During time at rest, the unit is allowed to cool to ambient temperature. This type of operation is usually random, not cyclical.

S2 = approx. 5 min. at full load

S3 - INTERMITTENT OPERATION
The unit runs in a continuous cycle of run time and idle time. During time at rest, it is not allowed to cool to ambient temperature. However, the unit has cooled sufficiently to allow for the next load cycle without exceeding the thermal limit.

S3 = approx 10% on-time per total cycle